Product Description:

The 2AD180C-B35RA3-BS23-B3N1 belongs to the 2AD 3-Phase Induction Motors series produced by Bosch Rexroth Indramat. As an AC induction motor, it converts electrical energy into rotational motion for conveyor lines, gantry axes, and other automated machinery. Its frame size and C motor length suit mid-range power output while providing the axial stack height needed for continuous torque. This configuration is commonly used where stable speed control and repeatable stopping behavior are required during production cycles. Standard bearings support the rotor, and an integral brake allows controlled stops during cycle interruptions.

An external radial blower directs cooling air across the housing to remove heat generated by copper losses, helping the motor sustain rated load. The brake is electrically released, so spring force holds the shaft when power is off and releases it when voltage is applied. Position feedback comes from high-resolution motor feedback, enabling the drive controller to regulate speed and torque with fine increment counts per revolution. The motor supports flange and foot mounting, so the frame can be secured either to a base plate or to a companion gearhead face. Three-phase supply conductors terminate inside a terminal box that provides strain relief and segregated grounding studs, which helps keep the wiring layout orderly.

The stator winding follows code BS to match the intended drive parameters, and vibration grade R indicates reduced residual imbalance for smoother operation. Power leads exit the housing on side A, and the designated connection position is on the right when facing the shaft, which helps organize cabinet routing. The shaft is supplied without a shaft seal and with full-key balancing, so an external seal is needed if fluid ingress is expected. Frame size 180 also sets the permissible overhung load range, and a second shaft end on side B is provided for encoder coupling or fan drive duties.