Product Description:

The 2AD180C-B35RA2-BS03/S002 is an AC induction motor built by Bosch Rexroth Indramat for the 2AD 3-Phase Induction Motors series. In automated plants, it converts three-phase electrical power into continuous rotary motion, providing the prime mover for conveyors, pumps, fans, and similar production equipment. By integrating the stator, rotor, and bearing set in a single enclosed frame, the motor supplies a compact drive source that can be coupled directly to mechanical loads within control cabinets or on open machine bases. This layout supports use in machinery that needs steady rotational output over long operating periods.

The frame uses motor size code 180, and the axial stack has length code C, which gives the motor its active iron height and overall power capability. Cooling is handled by an integrated Axial Blower, which forces air through internal channels to remove heat and maintain the rated thermal class during continuous duty. Mechanical attachment is flexible because the housing supports flange and foot mounting, allowing alignment to either a face plate or base rails. Electrical energy reaches the stator windings through a terminal box that houses screw terminals and sealing glands for power cables installed in the field.

The power feed enters the motor from Side A, which is on the right-hand side when viewed toward the shaft, and this arrangement simplifies cable routing inside multi-motor assemblies. Signal accuracy is improved by the embedded high-resolution motor feedback, which provides precise rotor position data to external drives for closed-loop control. Because the unit is supplied without a holding brake, motion systems that require static torque must rely on external mechanical locks or residual motor torque after shutdown. Dynamic behavior is supported by vibration grade S, and the BS winding works with the forced-air cooling layout to support stable operation under load.