Product Description:

The 2AD180C-B35RA1-BS03 is an AC induction motor manufactured by Bosch Rexroth Indramat in the 2AD 3-Phase Induction Motors series. In automated machinery it converts three-phase electrical power into continuous mechanical rotation for conveyors, tooling spindles, and pump drives. The standardized frame lets maintenance teams exchange identical units quickly during scheduled stoppages. Because the product type matches IEC dimensional codes, it can drop into existing motor mounts without redesigning brackets.

Heat is expelled by an Axial Blower, which forces air along the housing so the motor can run at its rated load without external cooling water. Frame designation 180 denotes a 180 mm stator diameter, giving a larger magnetic path and higher torque than smaller 2AD sizes. The active stack identified by C is the middle length in the family, balancing mass with continuous output. For installation, Flange and foot mounting provide either rigid face coupling or base-plate bolting. Motion control precision is supported by High-resolution motor feedback, delivering fine incremental position data to the inverter. Incoming conductors terminate in a gasketed Terminal Box that simplifies field wiring and shields the connections from oil or dust.

The motor is delivered without a holding brake, so static loads must be secured through external clamps or active drive torque. Winding selection BS specifies conductor cross-section and insulation class suited for 400 V mains and typical duty cycles. Power entry faces To Side A and, when viewed toward the shaft, the terminal box sits on the right, keeping cable bends short and leaving the blower outlet clear. These orientation and winding details complement the cooling and feedback features noted earlier by easing replacement, maintaining consistent phasing, and limiting downtimes.