Product Description:

The 2AD180C-B35OB1-BS23-B2N1 is an AC induction motor manufactured by Bosch Rexroth Indramat for the 2AD 3-Phase Induction Motors series. As a rotating prime mover, it supplies controlled torque to machine tools, packaging equipment, and material-handling axes within automated cells. It can couple directly to gear stages or belt transmissions where three-phase mains power and drive inverters are present.

An integrated cooling fan with an axial blower forces air through the housing to remove stator and rotor heat, allowing continuous output without derating. The motor carries an electrically released holding brake that engages automatically whenever supply power is removed, preventing load drift on vertical assemblies. Frame designation code 180 indicates the stator diameter and matches compatible mounting footprints. Position accuracy is enhanced by built-in high-resolution motor feedback, which returns fine incremental angle data to the drive for closed-loop vector control. Installation flexibility is provided by flange and foot mounting, so the unit can bolt to a base plate or to a gear housing without adapter brackets. Standard-grade bearings support the rotor, and length code C corresponds to the stack height used in this configuration.

The wiring scheme centers on a cast-aluminum terminal box that routes the power leads upward, with the conduit entry facing top and oriented to side B relative to the drive end. This arrangement shortens cable runs inside typical control cabinets. Dynamic balance is kept within vibration grade R, minimizing transmitted oscillations to precision fixtures. The mechanical output interface on the drive side is balanced with its full key and does not use a shaft seal, while the non-drive side remains closed because no shaft end is provided there. Winding code BS corresponds to impedance and current ratings suited to this motor configuration.