Product Description:

The 2AD180C-B35OB1-BS01-D2N1 is an AC induction motor manufactured by Bosch Rexroth Indramat for the 2AD 3-Phase Induction Motors series. In automated lines, it converts electrical power into rotational motion for gearboxes, pumps, and material-handling equipment. Its layout makes it suitable as a ready-to-mount drive source for machines that require integrated cooling and standardized mounting geometry. The motor is intended for industrial applications where continuous rotary output is needed across a broad range of operating conditions.

This model uses standard bearings that fit the motor’s radial and axial load limits without special preload arrangements. Cooling air is forced through the stator by an axial blower, so heat is removed even at low shaft speed. The frame follows size code 180, which corresponds to the motor’s stator diameter and torque class. The C length provides a longer active iron stack than shorter versions, which supports higher continuous output. Installation is supported by flange and foot mounting, so the same unit can bolt to a base plate or directly to a driven machine housing. No holding brake is included, so motion retention during power-off must rely on external means. Dynamic performance is classified under vibration grade R, which indicates balance quality for general-purpose industrial drives.

Electrical terminations are routed upward into a terminal box on top of the housing, and the cables exit toward side B to match common cabinet layouts. This arrangement keeps the connection area accessible and can simplify cable routing in enclosed machinery. Winding code BS identifies the wire gauge and turns count selected for the nominal voltage range used with Bosch Rexroth drive controllers. The driven shaft is a keyed shaft with a shaft seal, which helps transmit torque while limiting oil ingress at the main end. The secondary end is supplied without a protruding shaft, so compatible accessories can be mounted flush. A shaft seal also helps protect the bearing area from contaminants during normal operation.