Product Description:

The 2AD180C-B35OB1-BS01-A2N1 is an AC motor from Bosch Rexroth Indramat. It is built for the 2AD 3-Phase Induction Motors series. As an induction unit, it converts electrical power into rotational motion for conveyors, spindles, and other continuous-duty loads found in automated plant equipment.

This motor relies on an axial blower mounted on the housing to move air lengthwise across the stator and windings, keeping internal temperatures within the permissible range. Frame identification includes motor size code 180 and the C length designation so machine layouts can be matched to the housing envelope. The housing supports flange and foot mounting, so the same casting can use either mounting pattern without extra brackets. System wiring enters through a top-side terminal box that separates power conductors from feedback or brake cabling. The motor is supplied without a holding brake, so stop-and-hold functions must be provided electrically by the drive. Power enters the stator through lugs on side B, and standard deep-groove bearings guide the rotor under radial or axial load.

The shaft nose uses a smooth shaft without a seal, which reduces friction where sealing is already handled by the driven machine. Dynamic behavior is tightened by vibration grade R, which helps limit displacement amplitudes and supports alignment with precision couplings. Copper fill and lamination geometry correspond to winding code BS, which aligns impedance with matched frequency inverters. All power terminals sit at the top of the housing, leaving the side surfaces open for airflow and helping clearance around floor-mounted obstacles. Side B carries no secondary shaft end, allowing through-bolts or encoder hardware to mount directly against the rear cover. The C-length rotor shortens axial overhang, and the induction design regulates speed through slip rather than permanent magnets.