Product Description:

The 2AD180C-B35OA1-BS36-H2N1 is an AC induction motor produced by Bosch Rexroth Indramat for the 2AD 3-Phase Induction Motors series. It converts three-phase electrical power into rotational torque for conveyors, packaging stations, and material-handling axes in automated cells. The motor is built on the modular 2AD platform and is intended for use with compatible IndraDrive inverters. This arrangement supports continuous-duty operation where stable torque output and controlled speed are required. Because it is an induction motor used with an inverter-based drive system, it suits industrial applications that need durable operation over long production cycles.

Thermal management is handled by an integrated axial blower that moves cooling air along the stator during full-load operation. Position and speed are returned through digital servo feedback, allowing the drive to close the velocity loop without an external encoder. This feedback arrangement helps the control system maintain stable speed regulation during load changes and repeated motion cycles. The motor uses flange and foot mounting, so it can be installed by face attachment or by a base-mounted arrangement. Power conductors terminate inside a terminal box on the housing. The housing follows the 180 frame size used in the series, and the C length gives the motor a larger mechanical envelope than shorter versions in the same platform.

The drive end uses a shaft machined with a shaft seal and balanced with a half key, which helps limit contaminant entry while preserving rotor balance at higher speeds. A factory-fitted electrically released heavy-duty brake supplies holding torque when power is removed, which is useful on vertical or suspended loads. The motor is built to vibration grade R, helping limit transmitted vibration to connected machine structures. Wiring exits on side A through the top-mounted terminal location, while the opposite face is supplied without a shaft end so auxiliary equipment can be mounted there if needed. That layout keeps the connection area separate from the unused rear face and leaves room for related machine components. The BS winding code identifies the installed coil set for this motor version.