2AD160C-B35OL8-BS03-D2N1

Product Description:

The 2AD160C-B35OL8-BS03-D2N1 from Bosch Rexroth Indramat shows up in the 2AD 3-Phase Induction Motors series ready for steady work. The frame size clocks in at 160 mm, and it’s put together for both flange and foot mounting (B35), covering situations where lining things up close matters. The 24 kW rated power drops enough muscle for moving lines or stations without dragging on performance. Fasten this motor in and the blower cooling (OL8) option takes care of excess heat as the hours stack up, so the pace stays even when shifts run long and nothing gets bogged down.

Tough conditions don’t bother this motor with the IP65 enclosure protection across the outer case. Water splashes or dust in the air can’t slip in, so downtime from buildup or short circuits stays low. Torque is consistent too—the motor deals out up to 153 Nm rated torque, and heavy tasks settle into rhythm instead of fighting hardware and burning out. There’s a pipe connection keeping blower air moving in and out, which is handy when vent lines pack in hard-to-reach places or next to production cages. Hookup uses set connectors in the housing, keeping cables clear and minimizing snag hazards in busy areas.

A 400V supply feeds power, and control tech sticks to a D2 resolver for feedback. The feedback keeps the position on track anytime the line bumps and starts up from rest, so mistakes don’t creep in. Most mounting is straight—a few bolts in with the flange and job’s done. Put this type into bottling lines, picking robots, or sections where the shift needs motors not fussy about rough use. Finish lasts too—cleanups and wipedowns won’t chip away at performance. The 2AD160C-B35OL8-BS03-D2N1 lands in place for installers looking for control, output, and build that sticks through heavy cycles without complaint.