2AD160C-B35OL1-BS23-A2N1

Product Description:

The 2AD160C-B35OL1-BS23-A2N1 is slotted into the 2AD 3-Phase Induction Motors series from Bosch Rexroth Indramat and is picked for its mix of precision and raw power. With a frame size of 160 mm, this motor works with a rated voltage of 400V, making it easy to tie into common setups in automated lines or machining systems. Typical output floats at approximately 15 kW for rated power and can keep going up to 3000 rpm when higher speed is needed. Torque comes right in around 70 Nm, which is a sweet spot for motion tasks where heavier loads show up or start-stop cycles never really let up.

Everything gets wrapped in IP65 protection, which means nothing sneaky like dust or strong water jets gets inside, so reliability is boosted even in messier production halls. Cooling uses a forced-air blower, marked as "OL," blowing straight through the housing to bleed off extra heat—so the motor can keep up the pace shift after shift. The mounting checks off both flange and feet thanks to the B35 style, helping it bolt onto gearboxes, big machine frames, or tough conveyors where different anchor points matter. In places that run nonstop or see a bunch of resets, the multiturn absolute encoder (BS23) works out tracking, so position feedback lines up every time without needing to manually dial things back in.

The shaft solution brings a key and sealing ring setup. This holds coupling super tight, and the seal slows down grit or wash fluid from wrecking the innards. Weight for this whole thing runs up to 110 kg—big but still manageable with the right trolleys around. No brake and no frills—just a focus on steady electrical connections, shown by the A2N1 setup.