2AD160C-B35OA1-BS07-D2N1

Product Description:

The 2AD160C-B35OA1-BS07-D2N1 servo motor, made by Bosch Rexroth Indramat, is found in the 2AD 3-Phase Induction Motors series and works as a synchronous AC servo motor with a smaller 160 mm frame size. This lets it fit where larger motors might crowd the setup, but it still supplies a rated power of 5.0 kW, which covers moderate industrial loads just fine. Running it at a rated torque of 23 Nm puts enough power on the shaft to move parts and drive belts in automation systems. The rated speed goes up to 2000 rpm, so parts in a conveyor or robotic joint keep moving at a decent clip.

Cooling on this model uses a blower system (marked as type B); that design helps by moving fresh air across the whole motor, not just one corner. No worries about grime or splashes either, since the IP65 protection locks out the dust and water sprays that often float around in processing plants. For locking it into the machine line, there’s a connector that rotates so nothing binds or twists open. A resolver gives closed-loop feedback, aiming for more accuracy over the long run—misalignment is not much of a problem this way.

Weight for the 2AD160C-B35OA1-BS07-D2N1 sits at 55 kg, good for balance but not too heavy to mess up frame supports. Shaft sealing and a key on the rotor improve how the motor connects up—good options if side-loading happens or repeated stops and starts wear other builds down faster. Basic protection on the outside keeps shocks and chemical splashes away, lengthening operating life even when conditions aren’t the cleanest. This kind of motor installs well in big production cells where reliability matters but space does not allow bigger hardware.