Product Description:

The 2AD160C-B35LB2-BS03-B2N2 is an AC induction motor manufactured by Bosch Rexroth Indramat within the 2AD 3-Phase Induction Motors series. The unit converts three-phase electrical supply into mechanical torque for conveyors, packaging axes, and general motion stages in automated lines. It is intended for operation with Rexroth drives that provide vector control, allowing consistent speed regulation across a broad operating range. The size and length identifiers in the type code indicate the housing dimensions used for this motor.

Cooling is provided by an integrated axial blower, which forces air along the stator housing to remove heat generated during continuous duty. The motor is supplied without a holding brake, so torque retention during power loss must be handled by the machine mechanics or drive torque. The motor uses flange and foot mounting, allowing either face coupling or base plate attachment without adapters. The frame size is 160, and the length code C indicates a medium stack length that balances torque output with overall weight. Standard bearings support the rotor and provide the baseline bearing arrangement for rated operation.

Electrical termination is through a terminal box that exits to side B and is located on the left when viewing the shaft, which simplifies cable routing in common cabinet layouts. Inside the housing, the stator uses winding code BS, which matches the impedance and thermal characteristics expected by compatible drive modules. Rotor balance follows vibration grade S, which helps limit residual vibration at the coupling. A factory-installed high-resolution motor feedback device transmits precise rotor position data to the controller, enabling accurate vector control even at low speed. The output end is delivered without a shaft seal and is balanced with the entire key, while the opposite face has no shaft extension for applications that use a single shaft end.