2AD160B-B35OA1-BS03-A3N1

Product Description:

The 2AD160B-B35OA1-BS03-A3N1 is a solid induction motor out of the Bosch Rexroth 2AD 3-Phase Induction Motors series. The rated speed lands at 1500 rpm, which makes it good for setups that run consistent cycles and need a clean drive rhythm. It uses blower cooling marked as BS03, so there’s forced air involved—not passive—and that helps pull out extra heat during long runs. The mounting type is flange (B35), which handles vertical or horizontal positions fine, as long as the frame support holds. It’s not a light motor, either. The typical power floats around 22 kW, though that’s worth double-checking on the exact spec sheet since the model output can shift slightly.

The feedback system here is the A3N1 standard type, not fancy, just stable. Enough for a standard monitoring and loop control. An IP65 protection gives full dust lockout and keeps water spray from causing issues—solid for factory setups with coolant mist, dust buildup, or splash zones. The connection runs through a side terminal box, so wiring lines in from the edge, not top or bottom. The voltage is 400V, meaning it runs fine on most industrial three-phase networks. Once bolted in and wired, this motor usually doesn’t ask for much—just keeps going.

Size-wise, it’s part of the 160 frame group, which means it is bulkier than mid-range motors, but that’s expected at this power range. The flange design makes install less of a puzzle on machines already cut for B35. The 2AD motor series usually leans on long-term durability over fancy onboard tricks. That fits this model exactly. It runs clean, sits firm, and keeps turning under load without throwing weird errors. It is commonly spotted on presses, mill drives, and heavy conveyors. It is not built to impress—built to run; overbuilt, in a good way, just solid electric motion with proper airflow and sealed housing.