Product Description:

The 2AD134D-B05OA1-ES06-D2N1 is an AC induction motor produced by Bosch Rexroth Indramat for the 2AD 3-Phase Induction Motors series. As a mains-powered rotary actuator, it supplies continuous torque for spindle drives, material-handling axes, and other motion tasks in industrial automation lines. Integrated electrical feedback allows the connected controller to supervise speed and position, so the motor can maintain commanded profiles under variable loads and duty cycles. Its mechanical interface follows a common ISO flange pattern, supporting direct installation on compatible machine surfaces. Because it is intended for industrial drive systems, the motor is suited to repeated operating cycles that require stable output and consistent rotational behavior.

In operation, the motor is cooled by an internal axial blower, a forced-air unit that removes stator heat so rated output can be sustained in tight enclosures. Rotor position is reported through digital servo feedback, giving the drive controller a high-resolution signal for vector regulation. This feedback arrangement supports accurate speed control across a broad operating range and helps the controller react to changing load conditions. The motor has frame size 134 and uses flange mounting, so the housing can be attached directly to the machine. Winding code ES identifies the electrical configuration used for this version. Standard bearings carry radial and axial loads, and the unit is supplied without a holding brake to allow free coast-down when power is removed.

The active core length marked D increases continuous power without changing the motor’s footprint. Power cables enter on side A, and the terminals are positioned on the top face; a combined plug feeds both the stator and the blower. This terminal arrangement keeps the main electrical connections grouped in one area of the housing. The output shaft uses a shaft with a balanced key and shaft seal, which helps prevent oil ingress while preserving balance at high speed. Side B is left without a shaft end for encoder or bearing modules.