Product Description:

The 2AD100B-B05OB4-AS03-C2N1 is an AC induction motor built by Bosch Rexroth Indramat and included in the 2AD 3-Phase Induction Motors series. Rated for three-phase drives, it converts electrical energy into mechanical rotation for positioning, conveying, and process machines on automated lines. The unit’s integrated cooling system supports continuous operation, and the housing follows the 100 frame format used in this motor line. This layout helps the motor fit machine designs that use the same mounting pattern and general envelope.

An internal ventilation stage removes heat, and the blower is powered by 115 V. Because the cooling device is an axial blower, airflow moves parallel to the shaft to cool the motor during operation. For mechanical integration, the motor uses flange mounting, while standard bearings support the radial loads expected in normal service. The motor is supplied without a holding brake, so stopping and load holding must be handled by external equipment. Electrical power reaches the stator through a sealed connector that is oriented toward side B and exits at the top of the frame, which helps keep cable routing orderly in vertical installations. The drive end uses a smooth shaft with a shaft seal, and the rear side has no shaft end.

Rotor position is measured by high-resolution motor feedback, allowing the connected drive to monitor motion precisely. The 100 size code identifies the motor frame, while length code B indicates the active motor length used for this version. Electromagnetic behavior follows winding set AS, which is matched to the motor’s intended operating range. Structural balancing meets vibration grade R, which helps reduce transmitted vibration during rotation. The output is a smooth shaft with a shaft seal, helping protect the bearing area from contaminants while supporting direct coupling to the driven machine.