Product Description:

The 2AD100B-B05OA2-AS03-B2N1 is an AC induction motor produced by Bosch Rexroth Indramat within the 2AD 3-Phase Induction Motors series. As a rotary actuator for industrial automation, the unit converts electrical power into mechanical torque for conveyors, processing lines, and machine axes. It integrates into drive systems that require steady speed regulation and compatibility with Indramat servo inverters. This layout suits equipment that runs for long periods under repeated load changes.

Its cooling system relies on an axial blower that forces air across the stator laminations. The blower is powered by 230 V, so the motor can use the same low-voltage utility circuits that supply cabinet fans. Because the design is supplied without a holding brake, stopping torque must be provided by the drive or external mechanics. The shaft is supported by standard bearings to maintain alignment during continuous duty. Position data are returned through high-resolution motor feedback, enabling the drive controller to close velocity and position loops with tight accuracy. The housing is prepared for flange mounting, allowing direct attachment to gearboxes or machine plates without additional brackets.

The motor carries size code 100 and length code B, a geometry that balances torque output with moderate mass for medium-frame installations. Dynamic performance is set by vibration grade R, which supports applications where low oscillation of connected machine elements is important. Power enters through a plug-in connector on the top of the housing and is oriented toward side A, which can shorten cable runs inside a drive cabinet. The shaft is supplied without a seal and is balanced with a full key, while the rear end has no shaft extension. Winding code AS is used for the stator wiring pattern matched to compatible Indramat drives.