IE4132-0000 Beckhoff
Wake Industrial LLC is not an authorized distributor of this product.
No Tariffs On US Orders- Straightforward Pricing: No Rush Fees, No Credit Card Fees
The IE4132-0000 from Beckhoff is part of the IE Extension Box Units series and provides 4 analog outputs with a 16-bit resolution. It supports a maximum load voltage of 30 VDC and a load impedance greater than 5 kilo-ohms. This unit features M12 screw-in output connections and includes both M8 power feed and pass-through connectors.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The IE4132-0000 extension module is produced by Beckhoff for the IE Extension Box Units series. It is a sealed remote I/O block that brings four analog output channels directly to the machine frame over EtherCAT. By locating the converters at the field level, it shortens cable runs and lets controllers deliver voltage setpoints close to valves, drives, or positioning devices used in industrial automation. The IP67-rated enclosure tolerates the oil spray and vibration commonly found on harsh machinery.
Each channel uses a digital-to-analog stage with 16-bit resolution, allowing setpoints to be adjusted in 65,536 increments. New data appear at the terminals in < 4 ms, keeping pace with fast process loops. A voltage of up to 30 VDC may be applied, and the circuitry requires a load impedance of > 5 kΩ to limit current. Output energy comes from Load Voltage UP, while the drivers are referenced to the control-voltage domain, isolating the bus electronics from actuator spikes. Ground is shared with the 24 VDC supply, and the four lines use that reference because there is no isolation between channels. The four physical outputs correspond to the logical channels included in the device description.
The cyclic image transferred to the PLC contains 4 × 8 bits of control and status data plus 4 × 16 bits for the analog values, eliminating variable memory offsets. Voltage signals leave the unit through a single M12 screw-in socket. Field power is daisy-chained through a 1 × M8, 4-pin pass-through connector, with an identical M8 port used for the incoming feed. Because the actuator supply is already referenced to the 24 V ground, shield routing is simple, and only two supply conductors are needed alongside the EtherCAT cable. The actuator supply and separate control voltage help keep the output rails stable when high currents are switched elsewhere on the machine.
