Product Description:

The 8LSA44.DB060S200-3 is a three-phase synchronous motor built by B&R Automation for the 8LS Synchronous Motors series. Supplied under the 8LSA designation, the unit uses the standard configuration without reinforced bearings and fits machinery that requires compact, high-speed rotary actuation. In automated equipment, the motor converts servo inverter output into precisely regulated shaft motion for indexing, conveying, or tool-positioning tasks. The three-phase design supports smooth torque production and consistent speed control when paired with a compatible servo drive.

The rated speed reaches 6000 rpm, allowing fast cycle times in servo axes used for packaging or pick-and-place duties. Position feedback is handled by an inductive EnDat encoder that uses version 2.2 and delivers 19/12 bits of single-turn and multi-turn resolution, enabling fine interpolation across the motion profile. A multi-turn counter stores up to 4096 revolutions, so absolute position can be retained after power interruptions. The motor uses a 100 mm square flange pattern that aligns with IEC machinery faces, while length code 4 indicates the stator depth inside the housing. A smooth shaft end supports backlash-free coupling to gearheads or pulleys. This feedback arrangement allows the drive to read rotor position immediately at startup instead of depending on an incremental reference search.

Installation favors streamlined wiring because the power and feedback conductors share a single-cable solution terminated on a keyed connector at the rear of the frame. Heat is removed through self-cooling with free air circulation, eliminating the need for external blowers. A standard holding brake secures the load when the inverter is disabled, and the built-in multi-turn counter supports absolute position retention. The motor fastens to equipment through a mounting flange, is supplied in product revision 3, and is delivered without an oil seal. Using one cable for power and feedback reduces cable bulk at the motor and helps keep routing compact in crowded machine spaces. When fluids are present, the installation should provide suitable external protection around the shaft area.