8LSA44.D0030D000-0 B & R Automation
Wake Industrial LLC is not an authorized distributor of this product.
The B & R Automation 8LSA44.D0030D000-0 is a three-phase synchronous motor from the 8LS Synchronous Motors series. It has a rated speed of 3000 rpm and features a self-cooling, free circulation design. The motor comes with a 100 mm flange dimension, optical EnDat encoder technology, and a smooth shaft.
Internal Product Review
The 8LSA44.D0030D000-0 is a B & R Automation three-phase synchronous motor with self-cooling free circulation. Optical EnDat feedback with EnDat 2.2 gives the unit strong position integrity and dependable signal quality in servo applications. A rated speed of 3000 rpm and a smooth shaft make the design especially appealing for fast, clean machine integration.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The 8LSA44.D0030D000-0 is a three-phase synchronous servo motor produced by B&R Automation for the 8LS Synchronous Motors series. As a rotary actuator, it converts power from a matching inverter into continuous torque and speed for positioning or velocity control on packaging lines, pick-and-place gantries, and other industrial axes. Its mechanical design uses the series’ standard housing, keeping mass low while meeting the precision requirements of closed-loop motion systems.
The motor reaches a rated speed of 3000 rpm, providing a fixed upper limit for selecting gear ratios and feedback bandwidth. A flange face measuring 100 mm simplifies alignment with compatible equipment frames. Position feedback is supplied by an optical EnDat sensor that uses protocol revision 2.2. This interface provides absolute single-turn position data with a configuration of 25 single-turn bits and 0 multiturn bits, enabling precise loop closure in the controller. Heat is removed through self-cooling with free air circulation, so the motor does not require an external blower or liquid cooling circuit. The motor has length code 4, and its feedback electronics support single-turn operation only.
The electrical terminations exit through an angled swivel connector, and a standard connector housing provides the connection to the drive cabinet without loose pigtails. Torque is transmitted through a smooth shaft that is suitable for clamp or press-fit couplings. The frame includes a mounting flange for secure attachment and accurate alignment with the driven equipment. This configuration does not use a reinforced bearing, making it appropriate for applications with moderate radial and axial shaft loads. The motor is also supplied without an oil seal, so the shaft interface is intended for clean operating areas where exposure to liquids and contaminants is limited. A holding brake is not included, which means stationary loads must be retained by drive torque or an external mechanical device when required. The angled connector supports flexible cable routing around nearby machine components, while the smooth shaft permits direct installation with a compatible coupling. The 8LSA designation identifies the motor configuration within the product series, and its standard housing supports responsive acceleration by keeping rotational and structural mass moderate.
