Product Description:

The 8I64S200018.00X-1 inverter is produced by B & R Automation within the 8I6 ACOPOS Inverters series. As a compact motor drive, it accepts single-phase input and modulates frequency and voltage to regulate small induction or permanent-magnet motors in packaging, material-handling, and assembly equipment. The unit supports fieldbus connectivity through the series platform, allowing control systems to adjust speed and torque without additional electromechanical components.

The housing measures 72 mm in width, 145 mm in height, and 128 mm in depth, so it fits shallow control cabinets and aligns with a 60 × 121.5 mm mounting pattern. The drive provides a continuous motor output of 0.18 kW, representing the shaft power available to the connected motor under rated ambient conditions. Its input section accepts a single-phase supply, simplifying installation on light-duty utility lines. With a weight of 0.9 kg, the enclosure is suitable for DIN-rail or direct panel mounting without additional support brackets. Command processing on the logic inputs is refreshed every 4 ms, allowing the controller to detect fast status changes from upstream PLCs, while the 12.1 kΩ impedance prevents excessive loading.

The output stage is designed for low current loss; leakage is limited to 3 μA, and residual voltage remains below 0.3 V when the transistor is off. If a fault forces the channel to ground, integrated protection limits the peak short-circuit current to less than 35 A. Signal timing is fast, with a turn-on delay of less than 100 μs and a turn-off delay below 300 μs, making the device suitable for indexing drives that require rapid enable cycles. The electromechanical relay inside the safe-torque-off circuit is rated for 100,000 cycles. The X2x internal electronics consume only 1.6 W, so heat generation remains low during continuous operation.