8AC110.60-2 B & R Automation
Wake Industrial LLC is not an authorized distributor of this product.
The B & R Automation 8AC110.60-2 is part of the 8AC Powerlink Modules series. It supports a baud rate of 500 kbit/s through one CAN port with a 9-pin male DSUB connector. The module operates between 5°C and 40°C and features externally wired bus termination and RXD/TXD LED status indicators.
Internal Product Review
The 8AC110.60-2 is a B & R Automation Powerlink module with a 500 kbit/s baud rate and a 9-pin male DSUB connector. Externally wired bus termination and switch-based node address setting support straightforward commissioning in well-structured automation networks. Operation from 5°C to 55°C makes this module a strong fit for dependable industrial communication.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The 8AC110.60-2 is a communication interface module manufactured by B&R Automation for the 8AC Powerlink Modules series. This unit serves as a bridge between a local CAN segment and the deterministic Powerlink backbone, allowing distributed I/O, drive nodes, and other field devices to be integrated into a real-time machine network. By translating protocol traffic and presenting diagnostic LEDs, the module helps controllers coordinate motion sequences, safety interlocks, and process feedback within industrial automation cells.
The data channel on the module supports a transfer rate of 500 kbit/s, matching typical sensor bus requirements while keeping electromagnetic emissions low. The module has 1 CAN port, and its wiring is completed through a 9-pin male DSUB connector that mates with standard field cables used in control cabinets and machine-mounted equipment. To prevent signal reflections, the CAN line must use externally wired bus termination, which allows the network to end at this module or continue to another node. Electrical load on the control cabinet is minimal because the device draws only 0.7 W max. During operation, traffic activity is shown by RXD/TXD LEDs, allowing quick verification of message flow. The node address is set with a rotary switch, so setup can be completed without software tools.
The module can operate up to a surface temperature of 55 °C when installed under suitable cabinet conditions. When machinery is powered down, storage is permitted down to -25 °C, which is useful for unheated storage areas or seasonal shutdowns. For transport, the hardware tolerates temperatures up to 70 °C. This allows the module to remain protected during shipping and warehouse staging in warmer environments.
