80MPH4.600S114-01 B & R Automation
Wake Industrial LLC is not an authorized distributor of this product.
No Tariffs On US Orders- Straightforward Pricing: No Rush Fees, No Credit Card Fees
The B & R Automation 80MPH4.600S114-01 is an 80MP Stepper Motor from the 80M Stepper Motors series. It features an ABR incremental encoder and a high torque configuration with 2 motor stacks. This motor uses an 86 mm NEMA 34 flange and has an IP65 protection level.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The 80MPH4.600S114-01 is a stepper motor produced by B&R Automation for the 80M Stepper Motors series. It is intended for position-based motion tasks in industrial automation, where discrete angular steps support repeatable indexing and controlled movement. The motor can operate in an open-loop system, while its encoder also supports applications that require confirmation of rotor movement. Its standardized square mechanical interface allows connection to compatible gearboxes, linear stages, and direct-drive loads with minimal adaptation.
The front face measures 86 mm (NEMA 34), allowing the motor to fit mounting fixtures that use this established frame pattern. The rotor and stator use motor stack code 4 and a high-torque two-stack configuration, which increases magnetic capacity for greater holding torque at low speeds. The housing has an IP65 protection rating that prevents dust from entering and resists low-pressure water jets. This protection permits installation near washdown conveyors or on exposed gantry axes when the cable connections receive equivalent protection. An ABR incremental encoder provides position feedback so the controller can confirm movement, detect stalled operation, and support closed-loop microstepping. Design revision 01 identifies the initial released design for this model.
The motor is supplied with no brake, so stationary loads must be held by detent torque or an external clamping device after drive power is removed. Drive current uses a multiplier of x1 (100), which applies the nominal phase-current value directly without a scaling correction. The flange carries an H size designation for selecting compatible mechanical accessories, including couplings and terminal boxes. Classified as an 80MP stepper motor, the unit uses the winding arrangement, lead configuration, and thermal operating limits associated with that platform. Its step-based operation is suitable for indexing tables, feed mechanisms, and other automated axes that require controlled incremental movement. The encoder adds motion verification without changing the motor’s basic stepper operation, while the sealed housing supports use in industrial areas exposed to dust or occasional water spray.
