Product Description:

B & R Automation manufactures the 4PP152.1043-31 operator panel within the 4PP Power Panels series. The unit combines a touchscreen display with an embedded control computer, letting machine builders handle visualization, data entry, and local logic in a single front-mounted device for industrial automation cells. This integrated arrangement helps reduce the need for separate HMI and control hardware at the machine interface, which can simplify panel layouts and local operator access during routine operation.

The display offers a contrast ratio of 600:1, ensuring clear separation between light and dark elements under normal factory lighting. Luminance reaches 350 cd/m², so graphics remain readable even with bright overhead fixtures. Screen content is rendered at 640 x 480 pixels and spread across a 10.4 in (264 mm) active area, providing adequate space for process graphics without enlarging the enclosure. Electronics are supplied from 24 VDC ±25%; during switch-on, inrush peaks at 20 A for less than one millisecond while steady operation stays below 23 W. The LED backlight reaches half brightness only after 55,000 hours, and the front overlay carries two USB ports to load recipes or extract logs. Additional features include a serial channel rated to 115 kBaud, 2 MB of flash memory for onboard program storage, and a 423 × 288 × 65.5 mm housing that fits standard panel cutouts.

Computation is handled by a Geode SC2200 266MHz 32-bit x86 CPU partnered with 64 MB of DRAM, a combination sufficient for real-time HMI tasks and local PLC execution. Network traffic moves through an integrated controller that negotiates at 10/100 Mbps, enabling rapid program downloads and data exchange with higher-level systems. For environments that require wash-down cleaning, the anodized aluminum bezel carries a front protection rating of IP65, provided the mounting gasket is properly seated. The passive, fanless design avoids airborne dust and allows installation in cabinets where airflow is limited. It also removes the need for routine fan cleaning in locations where fine particles may collect around electronic equipment.