EEA-PAM-541-A-32 Vickers
Wake Industrial LLC is not an authorized distributor of this product.
Wake Industrial LLC is not an authorized distributor of this product.
The EEA-PAM-541-A-32 is a power amplifier from the EEA-PAM Power Amplifiers series, manufactured by Vickers. It has an input power of 50 watts, a nominal supply voltage of 24 VDC, and a mass of 330 grams. The amplifier supports a command voltage full scale of ±10 V and a maximum solenoid current of 3.2 amps.
Internal Product Review
The EEA-PAM-541-A-32 is a Vickers power amplifier designed for demanding electrohydraulic systems, featuring a ±10 V command voltage range and 47 kΩ voltage input impedance for precise control. With a maximum solenoid current of 3.2 A and automatic overload detection reset, it ensures reliable operation and system protection. This unit stands out for its dependable PWM drive type and efficient 24 VDC supply integration.
Have a part to sell?
Wake Industrial Warranty
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The EEA-PAM-541-A-32 is a plug-in power amplifier card from the EEA-PAM Power Amplifiers series manufactured by Vickers. Installed in a proportional valve control rack, the board converts low-level command signals into regulated solenoid current so hydraulic actuators follow the desired position or pressure profile. In automated machinery this module closes the loop between an electronic controller and the valve coil, letting the system adjust flow or force with pulse-width-modulated energy instead of direct line voltage.
A single 24 VDC rail supplies the card; the nominal line is kept within 24 VDC to ensure the onboard switching stage operates correctly. System power draw peaks at 50 W, a figure that defines cabinet ventilation needs. The command interface accepts a bipolar voltage span of ±10 V and presents a high-impedance load of 47 kΩ; this minimizes loading of upstream PLC or motion controller outputs. Where a current loop is preferred, an alternate ±20 mA input is available, buffered by a 100 Ω shunt so signal integrity is preserved over long cable runs. These electrical limits dictate the choice of field wiring and protect delicate analog sources from overdrive.
The power stage can deliver up to 3.2 A of solenoid current for full valve stroke yet idles at only 1.7 A when the command is zero, reducing heat during standby. A dedicated auxiliary supply of ±15 V at 50 mA supports external feedback sensors, and status points are routed through the DIN backplane via a DIN 41612 F48 edge connector. Automatic overload detection removes drive if coil resistance rises, then reinstates it once conditions normalize. Additional circuits include a 22 kΩ drive-enable gate, a 10 kΩ monitor output for scope checks, and a ±10 V reference source at 5 mA for field potentiometers. PWM drive topology, a 330 g card mass, and built-in reset logic together provide stable, compact control without extra cooling hardware.
