PY2C015U0XXXC05 Sanyo Denki
Wake Industrial LLC is not an authorized distributor of this product.
The Sanyo Denki PY2C015U0XXXC05 is a servo amplifier from the PY Super BL Servo Amplifiers series with an amplifier capacity of 15 Amps and a frequency characteristic of 400 Hz. It has a dynamic brake energy rating of 360 Joules and a dynamic brake delay of 10 milliseconds. The amplifier weighs 1.5 kilograms and features a velocity control range of 1 to 5000.
Internal Product Review
The PY2C015U0XXXC05 is a Sanyo Denki PY Super BL servo amplifier with 15 A amplifier capacity and 400 Hz frequency characteristics. A 1:5000 velocity control range and 10 ms dynamic brake delay support responsive, stable motion performance in precision drive applications.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The PY2C015U0XXXC05 is an AC servo amplifier produced by Sanyo Denki for the PY Super BL Servo Amplifiers series. Serving as the power stage between a motion controller and a brushless motor, it converts DC bus energy into a regulated three-phase output. This operation allows automated conveyors, pick-and-place robots, and indexing tables to maintain commanded speed and torque with minimal tracking error. The amplifier accepts a differential velocity command of ±2.0 VDC, and the control port has an input impedance of 10 kΩ to minimize the load placed on upstream circuitry.
The amplifier provides a continuous output current of 15 A, indicating the maximum motor winding current that it can sustain without thermal derating. It reproduces the velocity reference across a 1:5000 control range, providing fine resolution from crawl speeds to full-rate operation. The internal loop has a bandwidth of 400 Hz, allowing it to follow speed changes within that frequency range without significant phase lag. A built-in dynamic-brake resistor absorbs up to 360 J of regenerated energy during motor deceleration. Two monitor jacks provide current and velocity feedback signals at 0.5 V ±20%, allowing the signals to be observed with suitable diagnostic equipment. These outputs provide direct access to operating data without interrupting the command path or disconnecting the motor.
When the motor is disabled, the dynamic brake engages after 10 ms to reduce residual motion. The amplifier withstands operating vibration of 0.5 G and shocks of up to 2 G, helping it maintain stable operation when exposed to typical plant-floor disturbances. Leakage current is limited to ≤0.5 mA, making the unit suitable for installations that use ground-fault-sensitive protective devices. The housing measures 135 mm deep and 168 mm high and has a mass of 1.5 kg, reducing the load placed on the mounting panel. Its enclosure dimensions leave room for the airflow needed to remove heat from the power electronics. Proper cabinet spacing also prevents nearby components or wiring from obstructing the amplifier’s cooling path during extended operating cycles.
