PY2A015K0XXVP14 Sanyo Denki
Wake Industrial LLC is not an authorized distributor of this product.
No Tariffs On US Orders- Straightforward Pricing: No Rush Fees, No Credit Card Fees
The Sanyo Denki PY2A015K0XXVP14 is part of the PY Super BL Servo Amplifiers series. It supports single-phase control input and offers a built-in dynamic brake and brake energy rating of 360 Joules. The servo amplifier features a frequency response of 400 Hz and operates up to 90% relative humidity at a maximum altitude of 1000 meters.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The PY2A015K0XXVP14 servo amplifier is produced by Sanyo Denki within the PY Super BL Servo Amplifiers series. Intended for brushless motor axes, it converts bus energy into three-phase drive signals while receiving velocity and torque commands from a motion controller. In industrial automation, the unit provides precise acceleration, deceleration, and position-holding functions by coordinating motor current with feedback processing. Its control architecture supports regulated motion in equipment that requires consistent response throughout repeated operating cycles.
The control section tolerates an inrush current of 40 A, whereas the main stage draws 23 A at startup, so line components must withstand these brief transients. Normal operation relies on a single-phase input that supplies the amplifier during controlled motor operation. The built-in dynamic brake can absorb 360 J of regenerated energy during rapid deceleration, reducing the energy returned to the supply. Closed-loop speed regulation has a frequency response of 400 Hz, allowing the drive to follow command changes without noticeable lag. The velocity control range spans 1:5000, enabling the connected motor to maintain stable motion from creep speed to full speed without additional gearing. This broad operating range supports applications that alternate between slow positioning movements and rapid transfers.
The current and velocity monitor outputs use the same scaling, with each output centered on a reference of 0.5 V ±20%. This arrangement allows both signals to be compared with standard diagnostic equipment when evaluating loop behavior. The torque and velocity command inputs each have an impedance of 10 kΩ, limiting the electrical load placed on the connected motion controller. Operation is permitted at relative humidity levels up to 90% RH, allowing installation in a wide range of indoor industrial conditions. The amplifier can also operate at elevations up to 1000 m without derating. These operating limits allow the unit to be installed in control panels across facilities with varying humidity and elevation conditions.
