PY2A015A0M11P00 Sanyo Denki
Wake Industrial LLC is not an authorized distributor of this product.
The Sanyo Denki PY2A015A0M11P00 is a servo amplifier from the PY Super BL Servo Amplifiers series. This unit has a mass of 1.5 kg and a frequency response of 400 Hz. It supports a velocity control range of 1 to 5000 and features a maximum input pulse frequency of 2 million pulses per second.
Internal Product Review
The PY2A015A0M11P00 is a Sanyo Denki PY Super BL servo amplifier with a 400 Hz frequency response and a 1:5000 velocity control range. A 2M pulse/s maximum input pulse frequency and 10 ms dynamic brake delay support precise command tracking and confident stopping performance. Excellent tuning capability and stable control make this amplifier a strong choice for demanding motion applications.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The PY2A015A0M11P00 is a servo amplifier manufactured by Sanyo Denki for the PY Super BL Servo Amplifiers series. It converts pulse or analog reference signals into controlled motor current, allowing closed-loop velocity and torque regulation on industrial positioning axes, pick-and-place equipment, and high-speed conveyors. The Cn1 plug uses a 10250-52A2JL connector to route command signals and I/O to external controllers.
The command interface accepts an analog range of ±2.0 VDC through a 10 kΩ input. Digital motion commands can be supplied at rates up to 2 million pulses per second, supporting interpolated motion generators. In velocity mode, the amplifier maintains a loop bandwidth of 400 Hz, so it can follow rapid speed changes without excessive phase lag. Startup stresses are handled by a control inrush current peak of 40 A. The dynamic-brake circuit can absorb 360 J of kinetic energy and has an actuation delay of 10 ms, allowing it to stop loads quickly during faults. Current limiting is managed by an input of ±2.0 VDC with a tolerance of ±15%, and real-time phase current is mirrored on the 0.5 V monitor pin with a tolerance of ±20% for diagnostic use. A separate 0.5 V velocity monitor with a tolerance of ±20% reports tachometer output, allowing the response to be observed with an oscilloscope.
The speed loop has a 1:5000 control range, providing smooth regulation from creep feed to full rated speed. Power-on charging of the bulk capacitors draws a main inrush current of 23 A, which should be considered when selecting circuit protection. The chassis weighs 1.5 kg, making it suitable for installation in multi-axis automation cabinets where panel space and supported mass are limited. The protective earth conductor connects to an M4 terminal. Tightening that terminal to 1.18 N·m provides a secure safety-ground connection while helping prevent damage caused by insufficient or excessive torque.
