PY0A050T1FC1P01 Sanyo Denki
Wake Industrial LLC is not an authorized distributor of this product.
The Sanyo Denki PY0A050T1FC1P01 is part of the PY Super BL Servo Amplifiers series and has an amplifier capacity of 50 Amps with built-in regeneration resistance of 20 Ohms. It features a position control interface type, operates with a single-phase AC input of 200 to 230 Volts at 50/60 Hz, and supports an operating temperature range from 0 to 55 degrees Celsius. This full close type control unit uses an incremental encoder sensor at 2000 pulses per revolution and provides a velocity control range of 1 to 5000.
Internal Product Review
The PY0A050T1FC1P01 is a Sanyo Denki PY Super BL servo amplifier with 50 A amplifier capacity and a position control interface. Single-phase AC 200 to 230 V input and a full close control unit type support clean integration in precision motion systems. A 1:5000 velocity control range stands out as a strong performance feature for accurate servo tuning.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The PY0A050T1FC1P01 servo amplifier is produced by Sanyo Denki as part of the PY Super BL Servo Amplifiers series. It drives brushless servomotors while processing encoder feedback for closed-loop positioning. By converting incoming AC power into controlled current pulses and synchronizing them with the motor sensor, the unit forms the active link between a motion controller and mechanical axes in automated assembly, inspection, or packaging lines.
The drive outputs up to 50 A, delivering substantial torque for acceleration. Both the control and power circuits operate from single-phase AC 200 to 230 V at 50 or 60 Hz. During startup, the control path draws a peak inrush current of 40 A, while the main channel is limited to 18 A to simplify fuse sizing. Internal braking hardware dissipates up to 1800 J of regenerated energy per stop. The speed regulation range is 1:5000, allowing the amplifier to handle slow positioning and high-speed travel on the same axis. A full-closed control architecture synchronizes the internal position loop with the external motion controller. The current monitor produces 2.0 V per rated ampere, providing a signal that can be used to observe current behavior during setup and operation.
Overvoltage energy is shunted through a built-in 20 Ω resistor. The resistor is activated 24.0 ms after the dynamic brake command is issued. Position feedback is processed from an incremental encoder with 2000 pulses per revolution, which is compatible with the amplifier’s position-control interface. The velocity monitor produces 2 V for every 1000 rpm, allowing motor speed to be observed through an external measuring device. Continuous operation is permitted within an ambient temperature range of 0 to 55 °C, supporting installation in suitable electrical cabinets or machine enclosures. Adequate ventilation around the amplifier helps prevent heat from accumulating during sustained operation under load.
