PY0A050E0XXXP00 Sanyo Denki
Wake Industrial LLC is not an authorized distributor of this product.
No Tariffs On US Orders- Straightforward Pricing: No Rush Fees, No Credit Card Fees
The Sanyo Denki PY0A050E0XXXP00 is part of the PY Super BL Servo Amplifiers series and has an amplifier capacity of 50 Amps with a built-in dynamic brake. This position control amplifier supports a 200 VAC input voltage, 3-phase main input, and weighs 4.4 kg. It features a velocity range of 1 to 5000 and a frequency response of 400 Hz.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The PY0A050E0XXXP00 servo amplifier is produced by Sanyo Denki within the PY Super BL Servo Amplifiers series. This device drives matched Super BL servo motors and integrates into machine tools, pick-and-place robots, and packaging lines where rapid position loops are required. Acting as the power stage between a motion controller and a three-phase mains supply, it converts command signals into high-bandwidth current for precise industrial automation tasks.
The amplifier has a rated current capacity of 50 A, permitting high-torque acceleration without saturating the power stage. The control electronics draw only 40 VA, so panel auxiliary supplies remain lightly loaded. A 200 VAC three-phase supply feeds the power stage, which has a main inrush current of 18 A at power-up. The internal logic has a control inrush current of 40 A as its capacitors charge within milliseconds. Closed-loop response reaches 400 Hz when JL equals JM, providing tight position tracking when the load and motor inertia are equal. The current monitor produces an output of 2.0 V ±20%, while the velocity monitor produces an output of 2.0 V ±10%, furnishing real-time feedback to external controllers. Dynamic braking energy is dissipated through a resistor after a delay of 24.0 ms. Leakage current to ground is limited to 3.0 mA, supporting compliance with applicable safety standards.
A built-in dynamic brake eliminates the need for an external braking module and stops the motor when the command signal is removed. The power section accepts three-phase mains power, while the position-control interface supports pulse-train or analog reference inputs from CNC or PLC sources. A rated velocity range of 1:5000 enables slow creep movements and rapid indexing with the same tuning configuration. With a mass of 4.4 kg, the amplifier can be mounted on a suitable cabinet plate without requiring excessive support hardware. Its control and monitoring connections allow the motion controller to supervise operating conditions while issuing precise position commands.
