PY0A030E0XXYP00 Sanyo Denki
Wake Industrial LLC is not an authorized distributor of this product.
The Sanyo Denki PY0A030E0XXYP00 belongs to the PY Super BL Servo Amplifiers series and weighs 2.2 kg. It features a main circuit input of 3-phase 200-230 VAC at 50/60 Hz and a velocity control range of 1 to 5000. The amplifier supports a dynamic brake delay of 6.5 milliseconds and handles a dynamic brake energy of 360 joules.
Internal Product Review
The PY0A030E0XXYP00 is a Sanyo Denki servo amplifier engineered for precise motion control with a 1:5000 velocity control range and 400 Hz frequency characteristics. Three-phase 200-230 VAC main circuit input and ±0.1% load variation support consistent drive response in demanding automation service. A strong technical choice for accurate and dependable servo amplification.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The PY0A030E0XXYP00 servo amplifier is produced by Sanyo Denki within the PY Super BL Servo Amplifiers series. This unit conditions drive power for a matched BL servo motor and supplies closed-loop control signals for industrial automation axes that require rapid speed regulation and controlled dynamic braking. The amplifier handles both the control and main power sections, separating command electronics from motor power to support precise motion stages within Sanyo Denki’s drive platform.
The control section accepts single-phase 200–230 VAC at 50/60 Hz and draws a peak inrush current of 40 A when power is first applied. The main motor power section accepts three-phase 200–230 VAC at 50/60 Hz, and its initial magnetizing current is limited to 18 A, allowing coordination with standard branch protection. The command inputs are buffered, with both the torque command and velocity command inputs presenting an impedance of approximately 10 kΩ to reduce interaction with upstream motion controllers. Diagnostic feedback is available through a current monitor that delivers 2.0 V ±20% at rated current and a velocity monitor that outputs 2.0 V ±10% at 1,000 rpm. A dynamic-brake relay closes after 6.5 ms and connects an internal resistor, allowing the motor to dissipate regenerated energy rapidly.
The dynamic brake resistor has a capacity of 360 J, allowing it to absorb kinetic energy from high-inertia loads without exceeding its thermal limit. Speed-loop response is supported by a frequency characteristic of 400 Hz, while the amplifier regulates shaft velocity across a 1:5000 control range for slow indexing and high-speed positioning on the same axis. Closed-loop speed deviations remain within ±0.1% of maximum speed when line voltage or load changes, while temperature drift contributes no more than ±0.5% across the operating range. The amplifier has a mass of 2.2 kg, allowing installation in compact electrical panels without placing excessive load on the mounting surface.
