PY0A030E0XXXP00 Sanyo Denki
Wake Industrial LLC is not an authorized distributor of this product.
No Tariffs On US Orders- Straightforward Pricing: No Rush Fees, No Credit Card Fees
The Sanyo Denki PY0A030E0XXXP00 is a servo amplifier from the PY Super BL Servo Amplifiers series, featuring a built-in dynamic brake with a delay time of 6.5 milliseconds and supports regenerative processing with 20 W built-in regen power. The unit has a mass of 2.2 kg, offers a frequency characteristic of 400 Hz, and provides a velocity control range of 1 to 5000.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The PY0A030E0XXXP00 servo amplifier is manufactured by Sanyo Denki and belongs to the PY Super BL Servo Amplifiers series. The unit pairs with the manufacturer’s brushless servo motors to provide position-loop regulation in automated transporters, pick-and-place axes, and similar motion cells. By converting drive commands into precise current and voltage for the motor phases, it serves as the central interface between the controller and the mechanical load.
Its power stage contains a built-in regenerative resistor that can dissipate 20 W at 50 Ω, allowing low-level energy return without an external module when the axis decelerates. For heavier reverse power, the amplifier manages energy through built-in regenerative processing, and a dynamic brake engages automatically. The brake delay is limited to 6.5 ms, so motor torque is clamped quickly. When the command circuit is enabled, it may draw an inrush current of up to 40 A, which must be considered when selecting supply fuses and contactors. A current monitor terminal provides a diagnostic signal of 2.0 V ±20%, enabling the PLC to observe instantaneous phase current and verify load conditions.
For high-inertia stops, the dynamic brake absorbs up to 360 J per event. If recovery demands exceed that limit, an external resistor stack rated at 600 W can be connected. Servo stiffness is aided by a frequency response that extends to 400 Hz, and velocity regulation is supported across a 1:5000 range. Main power engagement produces an inrush current of 18 A, permitting the use of compact line contactors compared with those required for the control inrush. The amplifier reports speed feedback through a velocity monitor output of 2.0 V ±10%, and its mass is 2.2 kg for convenient panel mounting. Duct cooling is not supported; therefore, the chassis relies on ambient airflow.
