Product Description

The PMM-BA-5643-3 is a stepper motor driver built by Sanyo Denki for the control of stepper motor designs from the same manufacturer. The driver provides accurate control of the position, motion, and general operation of the connected motor. It is also a low cost device that does not require expensive and time-consuming maintenance operations. The housing of this product is made from aluminum material characterized by a high resistance to rust and deterioration. Various stepping motors of small to large capacities can be driven by this product without the need for adjustments for wide-range uses. Compared to other controllers with similar capacities, this product has a significantly smaller size that is perfect for areas with limited space.

The PMM-BA-5643-3 operates at an efficiency of about 95 per cent; it does not require too much current supply and is classified under the IP20 protection category. The operation of this product should be carried out under ambient temperature that does not exceed 50 degrees Celsius, and relative humidity should also be maintained below 85 per cent. This product unit operates with several input and output signals, including the command pulse input signal, power down input signal, step angle selection input signals, and phase origin monitor output signal. The typical insulation resistance of this product has a minimum value of 10 megaOhms.

The PMM-BA-5643-3 stepper motor driver is not built for use outside industrial environments; however, it should also be shielded from harsh conditions such as extreme vibration, water penetration and shocks. This product can be delivered to customers outside the United States through FedEx, UPS, or DHL. Wake Industrial also provide the motor with a 12-month warranty, which covers any damage that occurs during the proper use of the product.