P60B13150BXS1J Sanyo Denki
Wake Industrial LLC is not an authorized distributor of this product.
The Sanyo Denki P60B13150BXS1J is a brushless servo motor from the P6 Super BL Servo Motors series. It features a 130 mm flange size, 22 mm shaft diameter, and a rated output of 1500 W with a maximum speed of 2000 min-1. The motor uses a self-cooling method, is equipped with a wiring-saved incremental encoder with 2,000 P/R resolution, and offers IP67 protection.
Internal Product Review
The P60B13150BXS1J is a Sanyo Denki P6 Super BL servo motor with 1500 W rated output and brushless motor technology. Self-cooled operation and IP67 protection support dependable service in demanding machine environments. A wiring-saved incremental encoder with 2,000 P/R resolution stands out for clean feedback performance.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The P60B13150BXS1J is a brushless AC servo motor produced by Sanyo Denki within the P6 Super BL Servo Motors series. It is intended for closed-loop positioning and speed control in packaging lines, pick-and-place modules, and machine-tool feed drives where repeatable accuracy and quick response are required. Permanent-magnet excitation allows the motor to maintain torque without field windings, supporting efficient operation across repetitive motion cycles. The brushless design also avoids the mechanical wear associated with brushes and commutators.
This model delivers a rated mechanical output of 1500 W, enabling continuous torque for medium-duty loads at production speeds. Its commanded velocity reaches 2000 rpm, so axes can execute fast motion profiles without overspeeding the rotor. Position feedback is supplied by a reduced-wiring incremental encoder with a resolution of 2,000 pulses per revolution, which supports fine position detection before electronic interpolation. The IP67 enclosure resists dust ingress and temporary immersion, making the unit suitable for washdown areas when the rear glands are properly sealed. The square mounting face uses a 130 mm flange pattern that aligns with common IEC frames and supports straightforward integration into existing machinery. Self-cooling through the aluminum housing removes heat without requiring an external blower, reducing the number of auxiliary components around the motor.
The motor attaches by its flange and is supplied without a holding brake, so vertical axes must secure loads with an external locking device. A shaft seal helps prevent contaminants and moisture from reaching the internal bearings and other motor components. The internal insulation withstands a dielectric test of 1,500 VAC for 1 minute and maintains a minimum insulation resistance of 10 MΩ at 500 VDC to guard against moisture-induced leakage. The steel shaft has a diameter of 22 mm, allowing direct connection to compatible keyed hubs and rigid couplings. The housing has an overall length of 152 mm, which allows the motor to fit into machinery with limited axial installation space. Reduced encoder wiring also simplifies cable routing where several controlled axes are installed close together.
