P50B08100HXS9G Sanyo Denki
Wake Industrial LLC is not an authorized distributor of this product.
No Tariffs On US Orders- Straightforward Pricing: No Rush Fees, No Credit Card Fees
The Sanyo Denki P50B08100HXS9G is a brushless servo motor from the P5 Super BL Servo Motors series and has a rated output of 1000 W. It features a flange size of 80 or 86 mm and a shaft diameter of 16 mm. The motor operates at a maximum speed of 3000 min-1 and offers IP55 protection.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
Sanyo Denki’s P50B08100HXS9G belongs to the P5 Super BL Servo Motors series. This brushless AC servo motor converts electrical power into tightly regulated rotational motion, allowing positioning stages, packaging lines, and small transfer units to maintain repeatable trajectories under changing loads. Integrated feedback from its factory-mounted encoder lets the drive close the control loop at high bandwidth, so the motor acts as an actuator rather than a simple power source.
The motor delivers a rated output of 1000 W, and its winding is matched to a 200 VAC supply, permitting direct connection to common servo amplifiers. Under command, it can accelerate to 3000 rpm, while a wiring-saving incremental encoder with a resolution of 2,000 P/R reports position for precise servo regulation. The enclosure meets IP55, and the frame uses a fully enclosed, self-cooling design that eliminates the need for an external fan. The dielectric strength is verified at 1,500 VAC for one minute between the windings and housing. Insulation resistance is no less than 10 MΩ when tested at 500 VDC, maintaining electrical isolation even in damp production areas. The brushless design does not use commutators, which reduces maintenance requirements and supports continuous duty cycles.
For mechanical integration, the housing has a flange measuring 80 or 86 mm and a keyed shaft with a diameter of 16 mm, allowing direct coupling to gearboxes or timing pulleys. The overall length is 172 mm, supporting installation where axial space is restricted. The unit operates within an ambient temperature range of 0 to 40 °C and tolerates 20% to 90% relative humidity, making it suitable for general factory environments without dedicated climate control. Because no holding brake is fitted, an external locking device or servo torque must maintain the load position when required. Servo torque is unavailable after drive power is removed, so a mechanical locking device is necessary when the load must remain stationary during a power outage.
