Product Description:

The P10B10120HXSB6S is a brushless servo motor produced by Sanyo Denki within the P1 Super BL Servo Motors series. As a flange-mounted actuator, it uses a permanent-magnet excitation system to deliver controlled torque in positioning or speed-regulated axes. The wiring-saving incremental encoder feeds real-time rotor data to the drive for closed-loop regulation, making the unit suitable for pick-and-place machines, packaging equipment, and other automated assemblies that require repeatable motion.

The motor’s feedback circuit generates 6,000 pulses per revolution, allowing the controller to track rotor movement with fine resolution during positioning tasks. The electrical insulation withstands 1,500 VAC for 1 minute, helping protect the stator windings against high test voltages without insulation breakdown. A square flange measuring 100 mm provides a stable reference surface for rigid mounting and alignment with compatible gearbox faces. The rated top speed is 3,000 rpm, and the brushless design avoids the wear associated with mechanical commutators while providing controlled operation throughout its speed range. The motor uses Class F insulation, which permits higher winding temperatures than lower insulation classes.

The motor has a fully enclosed, self-cooled housing, allowing heat to dissipate from the exterior while helping isolate internal components from dust and oil. A shaft seal helps prevent contaminants from entering the bearing cavity, and the assembly is intended only for flange installation. Its continuous-duty operation permits sustained use at the rated load without requiring periodic shutdowns between operating cycles. Dynamic forces transmitted to surrounding machine frames remain low because the motor has a V10 vibration grade, which helps reduce unwanted vibration near sensitive equipment. The motor is supplied with no integrated holding brake, so stationary load retention must be provided by drive-applied torque or an external holding mechanism when required.