US1D200P10 Sanyo Denki
Wake Industrial LLC is not an authorized distributor of this product.
The Sanyo Denki US1D200P10 is a servo amplifier in the F SANMOTION Servo Amplifiers series. It has a driver mass of 0.09 kg and operates with an input source of 24 or 36 VDC. The device supports a maximum input frequency of 150 thousand pulses per second and features an open collector output system with a source current of 3 Amps.
Internal Product Review
The US1D200P10 is a Sanyo Denki servo amplifier engineered for stable pulse interface performance with a 24/36 VDC ±10% input source and a photocoupler input system. A 150 kpulse/s maximum input frequency paired with 3 A source current supports responsive command handling in compact motion assemblies. Class III protection makes the amplifier a strong choice for precise and dependable servo signaling.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The US1D200P10 servo amplifier is produced by Sanyo Denki as part of the F SANMOTION Servo Amplifiers series. The unit converts logic-level pulse trains into controlled current for miniature servomotors. This function makes it suitable for compact axes in semiconductor handlers, labeling machines, and other industrial automation equipment where installation space is limited.
It operates from a control supply of 24/36 VDC ±10%, and its command channel uses photocoupler isolation with an input resistance of 220 Ω to the upstream controller. This resistance keeps the LED current moderate when the sending side uses 5 V logic levels, reducing heat dissipation in the controller. The isolated input shields the amplifier from ground noise while accepting pulse signals at rates up to 150 kpulse/s, which supports fine-resolution motor positioning. During normal motion, the amplifier supplies up to 3 A of phase current, while the open-collector output stage limits feedback current to protect PLC inputs. Installation Category I and Protection Class III indicate that the device is intended for low-energy circuits within an enclosed machine panel. These classifications help reduce exposure to transient overvoltages when the amplifier is installed in an appropriate low-voltage control system.
The lightweight driver weighs only 0.09 kg, making it easier to place on compact DIN rail assemblies. A status transistor can sink up to 10 mA and tolerate 40 V across its collector and emitter, providing direct compatibility with common 24 V logic rails. Dielectric testing shows that the electronics can withstand 0.5 kVAC for one minute, while the measured insulation resistance is at least 10 MΩ when tested with 500 VDC. These electrical clearances support the insulation system and the safety requirements for low-voltage motion axes installed inside compact control enclosures.
