PRD-0051AMPz-X2 Kollmorgen
Wake Industrial LLC is not an authorized distributor of this product.
No Tariffs On US Orders- Straightforward Pricing: No Rush Fees, No Credit Card Fees
Current response time:
3 Minutes
41 Seconds
The PRD-0051AMPz-X2 is a servo amplifier manufactured by Kollmorgen as part of the VRDM Servo Amplifiers series. It delivers an output current of 15 Amps and operates with a 3-phase output voltage of 230 VAC. This amplifier features a DB25 Female amp-control port, a 24 VDC control voltage, and offers RS-232 serial interface connectivity.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The PRD-0051AMPz-X2 is a servo amplifier produced by Kollmorgen for the VRDM Servo Amplifiers series. Designed to convert a regulated DC bus into precise three-phase power, it drives closed-loop servo motors in conveyors, pick-and-place axes, and packaging equipment. The unit is manufactured in Israel and provides status feedback through two front-panel LEDs for on-site diagnostic visibility. By translating low-level current or velocity commands from a motion controller into high-bandwidth phase currents, it links electronic control logic to the mechanical load without requiring additional intermediary stages.
The power section delivers a continuous output current of 15 A through a three-phase bridge. This bridge generates 230 VAC at the output terminals, providing sufficient capacity for medium-frame permanent-magnet servo motors under dynamic duty cycles. The control electronics operate on an isolated 24 VDC rail, allowing the logic circuits to remain electrically separated from the main power section. Commands, enable signals, and analog references reach the amplifier through a DB25 female port, which also carries differential fault outputs. Operating parameters are retained in nonvolatile memory during extended shutdowns, preventing the loss of stored control settings when power is removed.
The input stage draws 9 A from a regulated supply of 350 VDC, allowing the module to share a centralized power stack while keeping ripple within the operating limits of its DC-link capacitors. Configuration data can be accessed through the RS-232 diagnostic link, which remains active when the drive is inhibited. This connection supports parameter review and adjustment without enabling motor output. Hardware revision H uses improved thermal vias and channelized airflow guides to reduce semiconductor junction temperatures during sustained acceleration profiles. The guided airflow directs heat away from the IGBT power section, while the existing mechanical footprint supports installation in established amplifier layouts.
