SC1E06260 Kollmorgen
Wake Industrial LLC is not an authorized distributor of this product.
The Kollmorgen SC1E06260 is part of the SC Servostar Servo Drives series and has a rated output current of 6 Amps. This servo drive supports input power of 115 VAC single-phase or 230 VAC single/three-phase and uses encoder feedback type with a 4x encoder line scale. The SC1E06260 weighs 2.36 kilograms, stands 256 millimeters tall, and mounts vertically for installation.
Internal Product Review
The SC1E06260 is a Kollmorgen SC Servostar servo drive with 6 A rated output current and flexible 115/230 VAC input compatibility. Vertical mounting and a 24 VDC logic supply support clean cabinet integration and straightforward control wiring. Encoder feedback through the C2 connector gives the drive precise signal handling, making SC1E06260 a strong choice for motion control applications.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The SC1E06260 is a servo drive produced by Kollmorgen for the SC Servostar Servo Drives series. It converts incoming AC or DC power into a precisely modulated output that controls compatible servo motors in automated machinery, allowing motion controllers to adjust speed and torque without mechanical throttling. By integrating encoder feedback, the unit maintains the precise position, velocity, and current control loops required in pick-and-place stations, indexers, and small conveyor modules.
The power section accepts a single-phase input of 115 VAC or 230 VAC, and it can also operate from three-phase 230 VAC mains when greater bus stiffness is needed. Its output stage delivers a continuous current of 6 A, so compatible motors must have a nominal phase current at or below that value. Control electronics are supplied by a dedicated 24 VDC logic rail that keeps the encoder and communication circuitry active during emergency-stop conditions. The vertical housing stands 256 mm high and measures 125 mm wide, providing a narrow footprint that fits high-density panels while leaving space for heat dissipation on both sides. The recommended side clearance is 12.7 mm, while the required spacing above and below the unit is 63.5 mm to preserve natural convection paths.
Encoder feedback is connected through a C2 receptacle that supports four-times encoder line resolution, giving the drive four quadrature counts per physical line and improving low-speed accuracy. The mounting bolts require a preload torque of 2.26 Nm, and the protective grounding point requires a separate M3.5 screw tightened to 1.35 Nm to provide a secure ground connection. The aluminum chassis weighs 2.36 kg, allowing installation on lightweight control doors without additional reinforcement. The drive must be installed vertically to maintain the internal airflow channel formed by the heat sink fins.
