M.1015.6922 Kollmorgen
Wake Industrial LLC is not an authorized distributor of this product.
The Kollmorgen M.1015.6922 is part of the MMC Standalone Smart Drives series and features a rated current of 6 Amps at 50 degrees Celsius and a rated voltage of 250VAC at 50 Hz. The drive supports an overload of 150% for 1 minute and 200% for 1 second, with a power loss of 3.5 Watts at full load. It weighs 0.3 kilograms and utilizes a 2mm square spring clamp terminal type.
Internal Product Review
The M.1015.6922 is a Kollmorgen MMC Standalone Smart Drive with a 6A rated current at 50°C and 150% one-minute overload capacity. A 2500VAC/1 minute electric strength rating and 2 mm sq. spring clamp terminals give the drive a well-engineered feel and make the unit a strong choice for reliable industrial motion control.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The M.1015.6922 is a compact drive controller produced by Kollmorgen for the MMC Standalone Smart Drives series. In machine tools, packaging lines, and small material-handling axes, this module combines power electronics with motion logic to operate a single-axis motor without a separate cabinet-mounted drive. It mounts directly on the machine frame, reducing wiring and control-panel space while supplying regulated AC power. Current limiting and protective monitoring support the closed-loop operation required for industrial automation tasks.
The drive accepts a mains supply of 250 VAC at 50 Hz and can deliver up to 6 A at 50 °C to the connected motor winding. Its dielectric insulation withstands 2500 VAC for 1 minute, allowing the control section to tolerate typical factory overvoltage tests. Protective earth leakage is limited to 5 mA at 240 V and 50 Hz, helping the unit meet applicable touch-current requirements. Power dissipation is only 3.5 W at full electrical load, which minimizes heat generation around the drive. The enclosure supports back mounting with four M4 screws or side mounting with two M5 screws. These attachment options allow installation on a panel or rail without additional brackets.
Short-term loading is supported by an overload capacity of 150% for 1 minute and a peak capacity of 200% for 1 second, providing headroom for acceleration spikes or stall recovery without immediately triggering a fault. Power and feedback conductors terminate in a 2 mm² spring-clamp terminal block, which enables toolless wiring and maintains secure connections under vibration. The housing weighs 0.3 kg (0.66 lb), adding little mass when installed on a moving carriage. Its compact housing permits placement near the connected actuator in decentralized machine layouts. Short cable runs between the drive and motor can also simplify routing where installation space is limited.
