Product Description:

The VP-507BEAN-12 is a motor power cable produced by Kollmorgen and supplied in the Kollmorgen Servo Cables series. It carries drive output current to a servomotor and returns protective earth for motion systems used in packaging lines, gantry stages, and similar automated equipment. The assembly is intended for industrial panels and managed routing paths where a factory-assembled connection is preferred over field-built wiring. Its conductor sizing and insulation system are matched to Kollmorgen servo drive requirements, which helps support consistent electrical performance without custom terminations. Because it arrives as a finished assembly, installation can focus on routing and connector placement instead of conductor preparation.

The minimum continuous routing radius is 94 mm, so the cable should not be bent more tightly than that during installation. Classified as a motor power cable, it uses copper power conductors and a drain wire to maintain a low-impedance connection between the inverter and the motor. Its outside diameter is 9.4 mm ±0.25 mm, which helps when selecting glands and clamp sleeves for secure entry points. The jacket is made of TPE, which resists industrial oils and remains flexible at low temperatures. The conductors are rated for up to 600 V AC, making the assembly suitable for connection to compatible servo drives.

The assembly weighs 1.789 kg, which helps keep added load low in supported cable runs and on mounting hardware. It is not rated for dynamic flexing, so it is better suited to fixed routing or low-cycle movement than to continuous motion in highly active cable tracks. The static flex classification is the same, which means hinged or torsional axes are outside its intended use. Thermal endurance reaches 105 °C at the conductor, allowing current load and surrounding cabinet heat to remain within the cable's temperature limit.