M.1302.8614 Kollmorgen
Wake Industrial LLC is not an authorized distributor of this product.
No Tariffs On US Orders- Straightforward Pricing: No Rush Fees, No Credit Card Fees
Current response time:
4 Minutes
27 Seconds
The Kollmorgen M.1302.8614 is a flex rated motor feedback cable from the Kollmorgen Servo Cables series, measuring 6 meters in length. The cable features a 15-Pin HD Male D-Sub connector at a 45 degree angle and supports BiSS or EnDat 2.1 feedback protocols. Its construction includes 7x28 AWG, 1x16 AWG, and 1x22 AWG wiring, and the feedback type is sine-encoder.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
Kollmorgen manufactures the M.1302.8614 cable as part of the Kollmorgen Servo Cables series. The item is a dedicated motor-feedback lead that links a synchronous servo motor to its drive, carrying encoder information needed for position loops in industrial automation equipment. By maintaining accurate differential signal integrity between the motor transducer and the controller, the cable supports closed-loop speed and position regulation on packaging lines, pick-and-place assemblies, conveyors, and other equipment that requires precise servo control.
The cable is 6 m long to accommodate typical cabinet-to-motor distances while leaving room for strain-relief loops. Its outer jacket is rated for continuous flexing, so it tolerates continuous motion in cable tracks without premature insulation fatigue. Internally, the conductors follow the arrangement 7 × 28 AWG, 1 × 16 AWG, and 1 × 22 AWG. The 28 AWG conductors carry differential encoder data, the 16 AWG conductor supplies sensor power, and the 22 AWG conductor handles auxiliary signals. To prevent conductor damage, the recommended minimum bend radius is 12 × O.D. At the drive end, a 45° backshell eases routing inside shallow panels, and termination is provided through a 15-pin HD male D-Sub connector that locks to the mating receptacle with thumbscrews. The motor side uses a straight molded connector to simplify inline installation and reduce unnecessary cable strain near the motor connection.
For drive compatibility, the assembly is keyed for the F1/F2 feedback ports found on Kollmorgen controllers. Encoder traffic follows the BiSS or EnDat 2.1 serial formats, allowing compatible drives to receive position data through the supported feedback interface. The cable’s impedance and shielding also support high-speed transmission of the analog sinusoidal signals used by a sine-encoder feedback chain. Its shielded conductor arrangement helps reduce interference when the cable operates in constantly flexing tracks or runs near motor power conductors.
