M.1302.8284 Kollmorgen
Wake Industrial LLC is not an authorized distributor of this product.
No Tariffs On US Orders- Straightforward Pricing: No Rush Fees, No Credit Card Fees
Current response time:
4 Minutes
31 Seconds
The Kollmorgen M.1302.8284 is part of the Kollmorgen Servo Cables series and is designed with a cable length of 4 meters and a conductor count of 4. This shielded cable features a digital drive interface, twisted pair construction, and uses a 6-pin male miniature circular DIN connector on one end with a 9-pin female D-sub on the other. It supports RS232 serial standard and is constructed from 24 AWG wire.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The M.1302.8284 is a servo feedback cable assembly from Kollmorgen and belongs to the Kollmorgen Servo Cables series. It links a servomotor or encoder to a drive so that position data and control signals travel reliably between the motion axis and controller in automated machinery. By matching the pinouts and electrical standards used by Kollmorgen digital drives, the cable supports direct signal routing without requiring custom wiring.
This model is supplied in a length of 4 m (13 ft), providing enough reach for typical cabinet-to-motor runs while keeping the cable manageable during routing. The jacket contains four conductors that accommodate transmit, receive, ground, and auxiliary signal paths used for serial feedback. Each conductor consists of stranded 24 AWG copper, which limits voltage drop over the cable’s full length while providing the flexibility needed for installation. The bundle is shielded to reduce electromagnetic interference from nearby inverters and power lines. Its shield is bonded from end to end through a shell-to-shell drain path, maintaining a consistent electrical reference between the connected devices. The individual data lines use a twisted-pair layout, which balances inductance and reduces crosstalk between signal paths during high-speed communication.
The cable provides digital interface compatibility, with a 6-pin male miniature circular DIN connector at the drive end and a 9-pin female D-sub connector at the motor or encoder end. The molded connectors use threaded collars or jackscrews to resist accidental disconnection when machinery produces vibration. Data communication follows the RS-232 standard, allowing the drive’s UART circuit to communicate directly with compatible Kollmorgen feedback electronics using the appropriate serial voltage levels. The connector shells carry the shield connection across the assembly, helping divert electrical noise away from the internal data conductors. Molded strain relief at each termination supports the cable near the connector bodies and reduces concentrated bending where the conductors enter the housings.
