CFE0A1-002-003-00 Kollmorgen
Wake Industrial LLC is not an authorized distributor of this product.
The Kollmorgen CFE0A1-002-003-00 is a 3 meter encoder cable from the Kollmorgen Servo Cables series. It features a 7x(2x0.25) cable composition, a conductor area of 0.25 mm², and supports EnDat/BiSS feedback. The cable has an AKD X10 Sub-D female drive connector and a 17-pin AKM&C/CH Connector 1.0 motor connector, with thermal protection included.
Internal Product Review
The CFE0A1-002-003-00 is a Kollmorgen encoder cable designed for EnDat/BiSS feedback and AKD X10 drive connection. The AKM&C/CH Connector 1.0 motor interface and connector-housing shield termination support clean signal transfer in servo installations. Included thermal protection adds practical reliability, making this cable a strong choice for precise servo feedback links.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The CFE0A1-002-003-00 encoder cable is manufactured by Kollmorgen and belongs to the Kollmorgen Servo Cables series. Designed as an interconnect between AKM servo motors and AKD drives, this cable routes incremental or absolute position data from the motor-mounted sensor to the controller, allowing the drive to close the position loop in automated machinery. As an encoder cable, it carries low-level differential signals rather than motor power, which helps isolate feedback data from electrical noise. This signal separation supports accurate position monitoring during speed regulation and coordinated motion.
The cable has an installed length of 3 m, which is suited to small and midsize machines with fixed spacing between the motor and control cabinet. It contains seven twisted pairs with two 0.25 mm² conductors per pair. Each conductor uses stranded copper with a cross-sectional area of 0.25 mm², supporting reliable data transmission while allowing the cable to flex during machine operation. The drive end is fitted with an AKD X10 plug that uses a female Sub-D connector, so the cable can attach to a compatible AKD drive without a breakout adapter. Individual pairs are wrapped in foil and surrounded by a collective braided shield. A drain wire provides an additional path for interference currents, helping protect high-resolution encoder pulses from common-mode noise. Thermal protection inside the jacket guards the conductors against localized heat from nearby power equipment.
At the motor end, an AKM&C/CH Connector 1.0 shell provides keyed engagement that helps prevent misalignment during connection. The contact arrangement has 17 pins, providing dedicated circuits for clock, data, and temperature channels used by the EnDat/BiSS feedback format. The cable shield is bonded directly to a connector housing clamp, establishing a low-impedance path that diverts electrical noise to ground before it reaches the feedback electronics. This direct shield connection helps maintain signal stability across the cable run. The internal thermal protection also helps preserve the insulation when the cable operates near heat-producing equipment.
