AKD-P00307-NDEI-0000 Kollmorgen
Wake Industrial LLC is not an authorized distributor of this product.
The AKD-P00307-NDEI-0000 is a servo drive from the AKD Servo Drives series manufactured by Kollmorgen. It supports Ethernet/IP fieldbus connectivity and operates as a position indexer. The drive has a nominal current of 3 Arms and a peak output current of 9 Arms, with a rated input power of 2.24 KVA for use with 240 or 480 Vac three-phase supply.
Internal Product Review
The AKD-P00307-NDEI-0000 is a Kollmorgen AKD servo drive with Position Indexer functionality and Ethernet/IP connectivity. Nominal output at 3 Arms and 9 Arms peak current for 5 seconds supports stable servo response during dynamic moves. Operation on 240 / 480 Vac 3~ makes the drive a strong fit for versatile industrial motion systems.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
Kollmorgen produces the AKD-P00307-NDEI-0000 within its AKD Servo Drives series. The unit is a digital servo amplifier that modulates three-phase power for torque, speed, and position control of synchronous or induction motors used in automated packaging lines, pick-and-place stations, and material-handling axes. It mounts on a DIN rail inside a control cabinet and uses forced-air cooling to remove heat during operation. The drive acts as the electrical interface between the machine’s control network and the motor, allowing coordinated motion commands to be converted into controlled motor current without mechanical throttling.
Its continuous output current is rated at 3 Arms, allowing the drive to deliver up to three amperes RMS to the motor windings without exceeding its continuous thermal limit. For rapid acceleration, the output can briefly increase to 9 Arms for five seconds, supplying the additional current needed to overcome load inertia. The power section accepts a three-phase input of 240/480 Vac, three-phase, allowing the same model to operate with either supported industrial supply voltage. At nominal load, the input has an apparent power draw of 2.24 kVA, which is relevant when selecting branch-circuit conductors and protective devices. Command and diagnostic traffic reach the drive through EtherNet/IP, supporting cyclic communication with compatible programmable logic controllers. This network connection carries operating commands and status information between the automation controller and the servo amplifier.
The drive uses a position indexer operating mode, allowing target positions, velocities, and dwell times to be stored and executed without a separate motion card. It is configured for Standard USA requirements, so its connector markings, fuse ratings, and agency approvals align with common North American control-panel practices. The chassis weighs 2.7 kg, limiting the mechanical load placed on the cabinet mounting surface while keeping the drive manageable during installation. Its compact cabinet arrangement leaves the power, motor, feedback, and network connections accessible for routing within the enclosure.
