Product Description

The Kollmorgen AKD-P00306-NBCN-0069 servo drive must be operated only in vertical orientation. This servo drive is designed to be operated between 0 °C and 40 °C. The product must incorporate only conductors made of copper for wiring. This device has the ability to modify the drive process variables for a base drive. The unit comes equipped with a motion bus and a TCP/IP service channel onboard. Its power section encompasses an IGBT module featuring floating current measurement at the output stage. This drive has no internal regen resistor. The product is widely used in combination with induction machines, linear motors and synchronous servomotors. This device has seven programmable digital inputs. The unit related parameters are set up using the WorkBench software. It uses its X12 and X13 RJ-45 connectors with six pins in each connector for the CANopen connectors. This drive transfers the boot up message along with the baud rate in its non-volatile memory after a power cycle in case of a fixed baud rate. The product related baud rate is assigned by setting the S1 rotary switch to 9 and the S2 rotary switch to any value from 0 to 4. This device comprises a B1 push-button that is used to start pre-defined functions. The servo drive should be assigned its static IP and DHCP IP only when the 24 V supply voltage is off. This unit has two very fast digital inputs that are suitable for electronic gearing and position latching. Its capture engine is polled every 62.5 µs. The product supports sink and source type sensors for its first two digital inputs. This device is highlighted by a floating reference common line for its Enable digital input at the X/4 terminal.