09.F5.CBB-YA53 KEB
Wake Industrial LLC is not an authorized distributor of this product.
The KEB 09.F5.CBB-YA53 is part of the F5 Combivert Axis Drives series. It features an input rated voltage of 400 VAC with a rated current of 6 Amps, and can deliver a maximum motor power of 1.5 kW. The drive provides analog input resolution of 11 bits with a scan time of 2 milliseconds, and its rated switching frequency is 8 kHz.
Internal Product Review
The 09.F5.CBB-YA53 is a KEB F5 Combivert axis drive designed for 400 VAC input and 1.5 kW motor power. An 8 kHz switching frequency and 11-bit analog input resolution support stable motor control and responsive command handling. The 90 °C maximum heat sink temperature reinforces dependable performance in demanding drive applications.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The 09.F5.CBB-YA53 axis drive is produced by KEB and belongs to the F5 Combivert Axis Drives series. Designed for machine-tool spindles, packaging equipment, and multi-axis material handling, the unit converts fixed-frequency mains power into a variable frequency and amplitude output that regulates asynchronous or synchronous motors in automated lines. In a control cabinet, it operates as a closed-loop interface between the motion controller and the motor, providing the modulation, protection, and diagnostic functions required for repeatable positioning and speed control throughout industrial automation cells.
The drive’s control channel samples each differential analog reference with an 11-bit converter that completes a full pass every 2 ms, allowing fine speed demand steps without aliasing. On the power side, it is rated for an input of 400 VAC on a three-phase supply, and the internal IGBT bridge switches at a carrier frequency of 8 kHz. Continuous motor feed is limited to an output current of 4.1 A, which corresponds to an apparent power of 2.8 kVA at nominal voltage. Current monitoring trips at 8.9 A, while a short-time surge of 7.4 A is permitted for acceleration. Cable runs between the drive and motor may reach 30 m at that switching frequency, helping limit excessive dV/dt.
The supply bus draws an input current of 6 A under rated load and is protected by a 16 A gL/gG main fuse. With these limits, the inverter can support motors up to 1.5 kW of mechanical output. Thermal management is handled by a heat sink that may dissipate 80 W of switching loss, while fan speed control keeps the aluminum base below 90 °C. During deceleration, the braking chopper diverts up to 7.5 A into an external resistor of at least 120 Ω, preventing DC-bus overvoltage. The protection limits support consistent fault handling during changing load conditions.
