09.56.200 KEB
Wake Industrial LLC is not an authorized distributor of this product.
No Tariffs On US Orders- Straightforward Pricing: No Rush Fees, No Credit Card Fees
The KEB 09.56.200 is an axis drive from the F5 Combivert Axis Drives series, featuring a rated power of 2.8 kVA and a maximum motor output of 1.5 kW. It operates on a single-phase 230 VAC input with a frequency of 50/60 Hz and has a rated current of 7.0 A. The drive has IP00 protection, measures 290 mm wide, 160 mm high, and 180 mm deep, and weighs 3.5 kg.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The 09.56.200 drive is produced by KEB and belongs to the F5 Combivert Axis Drives series. It is an AC inverter module that conditions single-phase input power and generates a three-phase output for positioning or speed-controlled motors used in industrial automation cells. By converting and regulating voltage and frequency, the unit permits a controller to run small servo or induction motors with closed-loop precision on assembly lines, material-handling axes, and compact processing machinery. Its inverter function also supports smooth acceleration, deceleration, and speed changes during normal machine cycles. This helps the connected axis follow commanded motion without requiring a separate motor starter.
The drive connects to a single-phase supply at 230 VAC and operates on either utility frequency of 50/60 Hz. Under nominal conditions, it draws 7.0 A and delivers a continuous apparent power of 2.8 kVA. Internally, the output stage can supply up to 1.5 kW of mechanical motor power, and the incoming circuit should be protected by a 20 A mains fuse. Phase conductors must be wired with a minimum cross-section of 2.5 mm² to limit conductor heating during operation. The three output terminals provide a symmetrical voltage pattern derived from the input supply, allowing the connected machine axis to receive variable-speed commands. The drive is suitable for installation sites up to 3000 m above sea level. Correct fuse sizing and proper conductor selection help the power stage remain stable during load changes and repeated starts.
Mechanical installation is through four holes with a 7.2 mm diameter, and the housing measures 290 mm in width, 180 mm in depth, and 160 mm in height. The chassis carries an open-frame IP00 protection code, so it must be installed inside a control cabinet with adequate airflow. Overall mass is only 3.5 kg, which helps simplify panel mounting and handling during installation. Because the enclosure is open, exposed live sections must remain protected by the cabinet structure and by proper spacing from nearby components. Short cable runs to the motor and orderly routing of power conductors can help reduce unwanted electrical interference. Adequate clearance around the inverter also helps limit heat buildup during continuous operation.
