Product Description:

The 07.F5.CBB-3BOA is an axis drive module manufactured by KEB as part of the F5 Combivert Axis Drives series. It is intended for closed-loop control of induction or permanent-magnet motors in material handling, pumping, and general automation equipment. By modulating output voltage and frequency, the drive enables precise speed and torque regulation that improves process accuracy while reducing mechanical stress on connected machinery. This control behavior helps the drive respond smoothly to changing loads during starting, steady operation, and deceleration.

The drive uses a nominal three-phase 400 V line connection. It supplies up to 0.75 kW of output power at a continuous output current of 2.6 A, and it can momentarily deliver 5.6 A during acceleration or brief load peaks. An integrated GTR7 braking chopper dissipates regenerated energy through an external resistor, which helps limit DC-bus overvoltage during rapid deceleration. The housing is size B with an IP20 enclosure, so the unit is intended for installation inside a switchgear cabinet. EMC category C1 supports use in environments connected to public low-voltage networks when the recommended filters are installed. Up to eight parameter sets are stored internally, and two analog outputs provide scalable voltage or current signals for monitoring.

A maximum switching frequency of 16 kHz supports finer current resolution and quieter motor operation. The control system executes command cycles every 2 ms and manages 8 digital inputs, 2 analog inputs, four software I/O channels, and a terminal strip with 29 points. This arrangement supports hardwired reference, enable, safety, and diagnostic connections without requiring extra interface hardware. Diagnostic tools can access the drive through its serial interface to adjust logic or view operating data without interrupting motion. The combination of flexible I/O and deterministic scan timing supports coordinated multi-axis use in packaging, conveying, and positioning systems.