Product Description:

KEB manufactures the 07.F5.A1D-2BGA axis drive as part of the F5 Combivert Axis Drives series. The unit functions as a variable-frequency inverter that regulates servo and induction motors in small conveyors, pumps, and positioners across general automation lines. By modulating the applied AC waveform, the drive supplies precise speed and torque commands while coordinating position feedback through dual encoder channels, making it a compact motion controller for cabinet-mounted installations.

The standard control board inside the drive provides I/O without extra option cards. The unit accepts a single-phase or three-phase supply at 230 V through its rectifier, allowing use on domestic and industrial mains. Internal circuitry lets the same hardware operate on single-phase or three-phase sources. During continuous duty, the inverter supplies 4 A, which supports up to 0.75 kW of mechanical output when the motor is matched. Brief overloads reach 7.2 A, and a factory-installed braking transistor channels surplus energy into an external resistor. Channel 1 and Channel 2 encoder inputs are differential TTL lines that terminate on D-Sub-15 and D-Sub-9 connectors for straightforward setup.

Switching devices in the output bridge are clocked as high as 16 kHz, reducing audible noise while maintaining accurate current vector control. The housing measures 90 × 250 × 181 mm and has an IP20 protection class, so it mounts inside a clean control cabinet without additional gasketing. Conducted emissions conform to the C1 EMC category, enabling use on public low-voltage networks when filters are installed. The drive’s twin encoder ports share a common shield ground that helps minimize interference at high carrier frequencies, and the rear heat sink mates directly with the panel to draw heat away from the insulated power stage.