00.F5.0C0.0001 KEB
Wake Industrial LLC is not an authorized distributor of this product.
No Tariffs On US Orders- Straightforward Pricing: No Rush Fees, No Credit Card Fees
The KEB 00.F5.0C0.0001 is part of the F5 Combivert Axis Drives series and uses an HSP5 adaptor with a special HSP5 cable for connecting a PC to a control board. This device enables RS232 to TTL signal conversion and supports voltage adaptation via adapter, using the diagnostic interface HSP5.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The 00.F5.0C0.0001 interface kit is supplied by KEB as a support accessory for the F5 Combivert Axis Drives series. It creates a temporary service link between a PC and the drive control electronics so operating data can be read or written without disconnecting the unit from the machine. In normal use, the kit supports setup and troubleshooting by translating standard computer signals into the low-voltage communication format used by the axis drive. Because the connection is temporary, it can be attached when access is needed and removed after the data exchange is complete. This allows the main installation to remain intact while still providing direct communication with stored drive information.
The kit centers on an HSP5 adapter that mates with the drive header, and an HSP5 special cable carries the data lines and reference connection between the host computer and the device. Its intended path is a PC-to-control-board connection path, so the computer acts as the active station while the drive responds to service requests. Electrical hookup is completed via an adapter, which avoids changes to the original machine wiring. The cable carries the communication lines and reference connection needed for reliable logic-state detection during direct access. Inside the adapter, a RS232-to-TTL level shift and voltage adaptation align serial signals with the 5 V logic domain used by the control board. That arrangement helps preserve signal quality over the short cable run used during service access.
The kit is used without an operator panel, so command entry and data access are handled from the computer instead of a local keypad. Continuous signal conversion inside the adapter helps maintain stable transmit and receive timing during parameter transfers and fault-log access. This arrangement is intended for direct communication with the control board when local operator input is not part of the connection. By bypassing local input hardware, the link reduces the chance of competing commands during an active access session. It is intended for cases where the PC is the only active service interface during the connection.
