00.F5.060-2100 KEB
Wake Industrial LLC is not an authorized distributor of this product.
The KEB 00.F5.060-2100 is part of the F5 Combivert Axis Drives series and features an RS232/RS485 interface type with D-Sub 9-pole connectors. It supports ANSI X3.28 and DIN 66019 protocols, with potential-separated isolation and a maximum auxiliary current of 10 mA at a +5 V aux supply.
Internal Product Review
The 00.F5.060-2100 is a KEB Combivert F5 axis drive serial interface module with RS232/RS485 communication and a D-Sub 9-pole connector. Potential-separated isolation and ANSI X3.28 support give the design a clean, dependable feel in industrial control applications. A well-executed option for stable drive communications.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The 00.F5.060-2100 communication module is manufactured by KEB as part of the F5 Combivert Axis Drives series. Mounted on the control section of an F5 inverter, the board adds serial data exchange so controllers, HMIs, or diagnostic tools can read parameters and issue commands during automated motion cycles. By inserting this option card, the drive gains a standardized link to external equipment without altering the power stage, which simplifies setup, monitoring, and remote access for drive-based machinery.
The module presents an interface labeled as RS232/RS485, allowing point-to-point or multidrop wiring depending on network size and noise conditions. Data framing follows ANSI X3.28, a character-based protocol that keeps telegram interpretation consistent across connected devices. Electrical isolation is provided by a Potential-Separated barrier that helps prevent ground loops between the drive and a supervisory PLC. Physical connection is made through a D-Sub 9-pole plug that is compatible with standard serial cables used in industrial settings. The board derives its logic power from the drive’s auxiliary bus and requires a stabilized +5 V supply so the communication electronics remain active whenever the control section is energized.
For European installations, the card also supports the DIN 66019 II and legacy DIN 66019 telegram sets, permitting data exchange with older CNC controllers. During idle states, the circuitry draws no more than 10 mA of auxiliary current, which places only a light load on the converter’s internal supply. Pin assignment is fixed, and the protective earth reference is routed to pin 7 to simplify shield termination when long cables are required. Because no encoder feedback card is fitted, this option slot is dedicated to serial communication, leaving other slots available for feedback or additional fieldbus hardware.
